# Raspberry Pi 2
[pi2]
kernel=rpi2-u-boot.bin

# Raspberry Pi 3
[pi3]
kernel=rpi3-u-boot.bin

# Raspberry Pi 4
[pi4]
kernel=rpi4-u-boot.bin

# Default Fedora configs for all Raspberry Pi Revisions
[all]
# Enable UART
# Only enable UART if you're going to use it as it has speed implications
# Serial console is ttyS0 on RPi3 and ttyAMA0 on all other variants
# u-boot will auto detect serial and pass corrent options to kernel if enabled
# Speed details: https://www.raspberrypi.org/forums/viewtopic.php?f=28&t=141195
# enable_uart=1

# Early boot delay in the hope monitors are initialised enough to provide EDID
bootcode_delay=1

# We need this to be 32Mb to support VCHI services and drivers which use them
# but this isn't used by mainline VC4 driver so reduce to lowest supported value
# You need to set this to at least 80 for using the camera
gpu_mem=32

# Use eXtended firmware by default
start_x=1

# New option to allow the firmware to load upstream dtb
# Will allow things like camera, touchscreen etc to work OOTB
upstream_kernel=1

# HAT and DT overlays. Documentation at Raspberry Pi here:
# https://www.raspberrypi.org/documentation/configuration/device-tree.md
# Each dtoverlay line is an individual HAT/overlay, multiple lines allowed
# The dtoverlay=upstream must be present for Fedora kernels
dtoverlay=upstream
# dtoverlay=rpi-sense

# Allow OS rather than firmware control CEC
mask_gpu_interrupt1=0x100

# Without this sdram runs at 400mhz, instead of 450
# https://github.com/Hexxeh/rpi-firmware/issues/172
audio_pwm_mode=0

# Other options you can adjust for all Raspberry Pi Revisions
# https://www.raspberrypi.org/documentation/configuration/config-txt/README.md
# All options documented at http://elinux.org/RPiconfig
# for more options see http://elinux.org/RPi_config.txt