>From a6fba82709859fc91e676ce53079eb250bb55750 Mon Sep 17 00:00:00 2001 From: Hans de Goede Date: Thu, 4 Aug 2011 14:41:07 +0200 Subject: [PATCH 27/28] usb-redir: Device disconnect + re-connect robustness fixes These fixes mainly target the other side sending some (error status) packets after a disconnect packet. In some cases these would get queued up and then reported to the controller when a new device gets connected. * Fully reset device state on disconnect * Don't allow a connect message when already connected * Ignore iso and interrupt status messages when disconnected Signed-off-by: Hans de Goede --- usb-redir.c | 22 +++++++++++++++++++++- 1 files changed, 21 insertions(+), 1 deletions(-) diff --git a/usb-redir.c b/usb-redir.c index 9ce2c8b..6d8f986 100644 --- a/usb-redir.c +++ b/usb-redir.c @@ -905,6 +905,11 @@ static void usbredir_device_connect(void *priv, { USBRedirDevice *dev = priv; + if (qemu_timer_pending(dev->attach_timer) || dev->dev.attached) { + ERROR("Received device connect while already connected\n"); + return; + } + switch (device_connect->speed) { case usb_redir_speed_low: DPRINTF("attaching low speed device\n"); @@ -933,19 +938,26 @@ static void usbredir_device_connect(void *priv, static void usbredir_device_disconnect(void *priv) { USBRedirDevice *dev = priv; + int i; /* Stop any pending attaches */ qemu_del_timer(dev->attach_timer); if (dev->dev.attached) { usb_device_detach(&dev->dev); - usbredir_cleanup_device_queues(dev); /* * Delay next usb device attach to give the guest a chance to see * see the detach / attach in case of quick close / open succession */ dev->next_attach_time = qemu_get_clock_ms(vm_clock) + 200; } + + /* Reset state so that the next dev connected starts with a clean slate */ + usbredir_cleanup_device_queues(dev); + memset(dev->endpoint, 0, sizeof(dev->endpoint)); + for (i = 0; i < MAX_ENDPOINTS; i++) { + QTAILQ_INIT(&dev->endpoint[i].bufpq); + } } static void usbredir_interface_info(void *priv, @@ -1037,6 +1049,10 @@ static void usbredir_iso_stream_status(void *priv, uint32_t id, DPRINTF("iso status %d ep %02X id %u\n", iso_stream_status->status, ep, id); + if (!dev->dev.attached) { + return; + } + dev->endpoint[EP2I(ep)].iso_error = iso_stream_status->status; if (iso_stream_status->status == usb_redir_stall) { DPRINTF("iso stream stopped by peer ep %02X\n", ep); @@ -1054,6 +1070,10 @@ static void usbredir_interrupt_receiving_status(void *priv, uint32_t id, DPRINTF("interrupt recv status %d ep %02X id %u\n", interrupt_receiving_status->status, ep, id); + if (!dev->dev.attached) { + return; + } + dev->endpoint[EP2I(ep)].interrupt_error = interrupt_receiving_status->status; if (interrupt_receiving_status->status == usb_redir_stall) { -- 1.7.5.1